![topic](https://www.networkbulls.com/ask/public/images/topic_default.png)
Switch
Questions 37
Answer 37
Views 109125
Do you have any Question?
Recommended
Switch Feed
Major Differences between Cisco Router and Switch:
Both Routers and switches are networking devices which allow co...
![author](https://lh6.googleusercontent.com/-yTn5BiDij4E/AAAAAAAAAAI/AAAAAAAAAcU/3KUglVMh3hw/photo.jpg)
,
Principal Network Architect - Array Networks
Principal Network Architect - Array Networks
Cisco router's and switch's interfaces have the capability to work at full duplex as well as half duplex. ...
![author](https://www.networkbulls.com/ask/public/uploads/profile/10154342920249147.jpg)
,
ZAP
ZAP
Just enter interface
CLI
Int fa1/0/10
no switchport port-security
![author](https://www.networkbulls.com/ask/public/images/trainer/2017-07-05-12-19-38-PiyushKataria (2).jpg)
Catalyst Switches : Catalyst is a brand which intially sell it's swtiches to users and use it's own o...
![author](https://www.networkbulls.com/ask/public/uploads/profile/118399238727111704813.jpg)
,
CCNA Routing and Switching
CCNA Routing and Switching
You can set up a static ARP entry on the Cisco router to bind the unicast virtual IP address to the multicast MAC a...
![author](https://www.networkbulls.com/ask/public/uploads/profile/107281768900633437501.jpg)
,
An IT Geek
An IT Geek
Interface Status and Line Protocol :
Router : In case of Router by default all ports are adminis...
![author](https://www.networkbulls.com/ask/public/uploads/profile/118399238727111704813.jpg)
,
CCNA Routing and Switching
CCNA Routing and Switching
Hub:
--It is a layer 1 device.
-- Just Flood every data it receives [ don't maintain any table ]
--Usual...
![author](https://www.networkbulls.com/ask/public/uploads/profile/118399238727111704813.jpg)
,
CCNA Routing and Switching
CCNA Routing and Switching
If you create a SVI , you are creating a logical interface for a vlan but when you run no switch port command y...
![author](https://www.networkbulls.com/ask/public/images/trainer/2017-07-05-12-19-38-PiyushKataria (2).jpg)
The feature arp-inspection is only used to avoid the arp spoofing attack in your case as iam able to see the output...
![author](https://www.networkbulls.com/ask/public/images/trainer/2017-04-21-12-17-35-ajay.jpg)
In MPLS LDP is used to exchange label information and still it is dependent on IGP for building forwarding tables.S...
![author](https://www.networkbulls.com/ask/public/images/trainer/2017-07-05-12-19-38-PiyushKataria (2).jpg)
Aman if your OS X machines are not sending discover message try this command in terminal
sudo ipconfig set D...
![author](https://www.networkbulls.com/ask/public/uploads/profile/1510558669004638.jpg)
,
ZAP
ZAP
I myself got the answer, the range of 4094 is for all the switches in a stack because when the switches are connect...
![author](https://www.networkbulls.com/ask/public/uploads/profile/113813428079890240521.jpg)
,
ZAP
ZAP