I Perform ARP Spoof Attack And I Also Enable Arp Inspection On Switch Switch Will Detect Arp Attacks But Not Able To Prevent These Any Prevention Method To Stop ARP Attacks?

The feature arp-inspection is only used to avoid the arp spoofing attack in your case as iam able to see the output it is showing the logs of invalid arp requests as you said its not working may be due you are doing it on GNS some features of the switches are not supported on gns the commands to enable the feature may be available in console but it may be possible that feature dont work as it should work according to the concept.

IN the logs its clearly shown that Dynamic arp inspection is denying the invalid arp requests to verify whether it is working or not connect two hosts to the switch and try sending some ping messages if pings are successful after enabling arp inspection then it means its not working and also make sure hosts must not send any arp requests before you enable arp inspection on the switch because if arp is resolved before enabling arp inspection on the switch then you will not get desired results and last make sure host ports are untrusted for arp-inspection feature before we send any message